Davies Craig digital thermatic fan switch (12V & 24V)

Kit content:

• 1x Digital Fan Switch IP66
• 1x Thermal Sensor Probe
• 1x Mounting Kit for Thermal Sensor Probe
• 1x Red 6mm Ring Terminal
• 1x Blue 6mm Ring Terminal
• 2x Blue Wire Joiner
• 2x Self Tap Screw
• 1x Instructions

The sensor, a Temperature Probe (Air or Coolant Fitment), senses air temperature as it passes through the radiator with the sensor placed in the radiator fin section, or the sensor can also be placed directly into the coolant system.

Sensor Wire length:

• 142cm in total (Wire from switch 112cm plus sensor connector 30cm)
  
  
  

The switch can run 1 or 2 fand for 12 or 24-volt applications. It has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF), which can show Centigrade or Fahrenheit.

Fan #1 will start once the temperature reaches the set temperature.
Fan #2 (if applicable) will start operation 10 seconds after fan #1 starts.
The fan/s will operate until the temperature falls by 5°C below the set temperature.

IP66 Rated:

• Protected from total dust ingress
• Protected from high-pressure water jets from any direction, limited ingress protection
• Not waterproof

AIR TEMPERATURE APPLICATION

It senses air temperature as it passes through the radiator and has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF).

The Temperature Sensor is placed in the radiator fin section as close to the hot coolant inlet as possible; no need to cut hoses or it can be placed directly into the coolant system.

WATER / COOLANT APPLICATION

The 0444 sensors can also be placed directly into the coolant system.

SPECIFICATION

• Max voltage: 12 to 27V (For 24V, relays need to be changed, not supplied in kit)
• Max current: Rated to 30 amps per Fan (Maximum 40amp per Fan) Unit comes with 2 x 30 amp fuses and 2 x 40 amp relays
• Relay setup: Dual relay
• Sensor Wire length: 142cm in total (Wire from switch 112cm plus sensor connector 30cm)
• Speed: Single speed, 10-second delay to start up the second fan
• Applications: Suitable for single and dual fan applications
• Screen Display: LED digital temp display, actual temp + set temp
• Temp Display: Centigrade or Fahrenheit
• Temp settings: 40°c to 110°c (104°F to 230°F)
• Temp setting: Push Button
• Circuit type: Pre-programmed microcontroller
• Output wires: Batt + Batt - IGN, AC Clutch, Fan #1, Fan #2 Thermistor Probe
• Dimensions: 95x65x56 mm